A dishwasher’s interior light came on, but the control panel would not power up to start a cycle.
What our technicians usually find: the door latch switch, the control board or the user interface panel, or a loose connection behind the panel.
Dishwasher dead, leaking from the dispenser, or leaving dishes dirty? We repair dishwashers across Falls Church, including retrofits in older kitchens, and you'll have the price before we start.
Appliance Surgeon offers same-day and next-day visits to Falls Church homes and buildings. The $75 diagnostic visit is credited to the repair, labor starts at $200 on about 9 in 10 repairs, and every repair carries a 90-day parts-and-labor warranty.
Schedule service in Falls Church
Same-day and next-day visits.
Open 7 days until 10 PM (Sundays from 10 AM)
Diagnostic visit: $75, or $115 for a double unit.
Credited toward your repair when you approve the quote.
90-day warranty on parts and labor, and a written quote before any work starts.
Many Falls Church houses were built before dishwashers were standard, so the one you have was likely fitted in later. Retrofit installs are where you find a drain hose with no high loop, a supply line pulled a little too tight, or a dishwasher sharing a circuit with another kitchen appliance. Each of those can look like a dishwasher fault, so the technician checks the hookup before testing parts.
The supply side matters as much as the drain. In January 2025, a KitchenAid in the City of Falls Church (22046) leaked under the front right corner, and only while it filled. The cause was a cracked water inlet valve plus a loose copper supply fitting, and replacing the valve and tightening the fitting stopped it. A leak that shows up only during fill usually points to the valve or the supply connection, while a leak during the wash more often comes from the door gasket or a spray arm.
A dark control panel is another common call. A GE in Shirlington, in the cards below, had a completely dead panel with the breaker on, and a March 2026 Falls Church request described a dishwasher whose light came on while the panel stayed blank. Technicians usually find the control board, the door latch switch or a thermal fuse, and the cheaper latch and fuse get tested first.
The other card, a KitchenAid in South Arlington, had a detergent door that wouldn't open fully and a rinse-aid dispenser leaking into the tub, which comes down to a worn dispenser assembly. A sticking detergent door is easy to miss. If the pod or powder is still in the cup at the end of the cycle, the dishes were washed in plain water. Make sure a tall pan or a utensil isn't blocking the door before blaming the dispenser.
Pumps, valves, latches and dispensers are usually worth repairing. A cracked tub or a rusted frame on an older machine is where replacement makes more sense, and the repair-or-replace calculator can help with that call.
When you book, open the door and look for the model label on the edge of the tub or the side of the door. If it leaks, shut the valve under the sink first. If you rent near Seven Corners or on West Broad Street, the landlord usually decides on the repair, so ask management to approve it or book it with us.
Updated November 2026.
A dishwasher’s interior light came on, but the control panel would not power up to start a cycle.
What our technicians usually find: the door latch switch, the control board or the user interface panel, or a loose connection behind the panel.
A KitchenAid dishwasher leaked under the front right corner while filling.
Repair: Replaced the cracked water inlet valve and secured the copper supply fitting.
From our technicians’ service log and online repair requests; customer details are kept private. A request shows what the customer reported; the technician confirms the cause on site before quoting.
A KitchenAid dishwasher had a detergent door that would not open fully and a rinse-aid dispenser leaking into the tub.
What our technicians usually find: a worn detergent or rinse-aid dispenser assembly.
Dishwasher repair in ArlingtonA GE dishwasher had a completely dead control panel with the breaker on.
What our technicians usually find: the control board, the door latch switch or a thermal fuse.
Dishwasher repair in ArlingtonCompany data; customer details are kept private. “What our technicians usually find” is the common cause of that problem, confirmed by our team. The technician confirms the cause on site before quoting.
The checklist our technicians follow on every visit is on the Dishwasher Repair page.

Seeing an error code on the display? Look it up: LG dishwasher, Samsung dishwasher, Whirlpool dishwasher, GE dishwasher, Bosch dishwasher, Frigidaire dishwasher, Thermador dishwasher, Miele dishwasher, or browse all error codes.
Before you book in Falls Church, VA, these guides explain the most common symptoms, which checks are safe to try yourself, and when a technician should take over. All guides.
Every appliance we repair in Falls Church is on one page: appliance repair in Falls Church, VA. You can also go straight to refrigerator repair, freezer repair, washer repair, dryer repair, oven repair, stove and range repair, cooktop repair, microwave repair, range hood repair, wine cooler repair or HVAC repair, all in Falls Church.
We also provide dishwasher repair in Arlington, VA, dishwasher repair in McLean, VA, dishwasher repair in Annandale, VA, dishwasher repair in Tysons, VA and dishwasher repair in Vienna, VA.
This location is part of our dishwasher repair coverage across the DC metro area. See all appliance repair services in Falls Church, VA.
Neighborhoods we regularly cover in Falls Church, VA: the City of Falls Church, Seven Corners and Idylwood.
We're based in Alexandria, about 9 miles from Falls Church. Same-day and next-day appointments are available when the technician route has open windows; call or book online for the earliest option. Appointments cost the same on weekdays, evenings and weekends - our hours run 8 AM to 10 PM Monday through Saturday and 10 AM to 10 PM on Sunday, all at one standard rate.
Many dishwasher repairs are completed in a single visit once the technician has diagnosed the fault and confirmed the parts on hand. If a specific part has to be ordered, we schedule a short return visit to finish the job.
Appliance Surgeon charges $75 for the diagnostic visit, or $115 for a double unit (such as a double wall oven, washer-dryer combo or stacked laundry), and the fee is credited toward the repair if you approve the quote. Labor starts at $200 and stays there on about 9 in 10 repairs; more complex jobs can reach $450. Parts are extra and listed in the quote. Clogged filters and drain pumps sit at the lower end; circulation pumps, heaters and control boards climb from there. Diagnosis comes first and the exact quote before any work - and where hard water is the real culprit, we tell you rather than replacing parts that were never the problem. Typical price ranges by appliance are in our appliance repair cost guide.
Common calls include dishwasher not draining, dishwasher leaking, dishes not clean, bad smell, cycle not finishing and door latch issues. The exact cause is confirmed during diagnosis.
Something stopped the dispenser door from opening. First check that a tall item or the lower rack isn't blocking it. If the door still sticks, the dispenser assembly is worn or its latch has failed. It's a common and fairly inexpensive repair.
Maybe. A failed control board is one cause, but a door latch switch or a blown thermal fuse can also leave the panel dark. Both are cheaper than a board, so we test them first.
Safe first steps: clean the filter at the tub floor, make sure the spray arms spin freely, and confirm the door latches firmly. Water, electricity and pumps live close together in a dishwasher, so anything past those checks belongs to a technician.
A fill-only leak usually starts at the water inlet valve or the supply connection behind the kick plate. In January 2025, a KitchenAid in the City of Falls Church leaked at the front right corner during fill because its inlet valve had cracked and the copper supply fitting was loose. Turn off the valve under the sink, put a towel down, and tell us whether the line is copper or braided when you book.
It can. Retrofit dishwashers often have a drain hose without a high loop, a hose that sags or kinks behind the cabinet, or a long run to the sink drain. Any of those can leave dirty water in the tub or let it siphon back. The technician checks the hose route and the filter before testing the drain pump, so you don't pay for a pump the machine doesn't need.