July 2026 · Arlington, VA
A Samsung hood with a burned-out motor, to be replaced with a Z-Line hood the owner had already bought.
We install replacement range hoods: under-cabinet, wall chimney, island and insert hoods, and downdraft vents. The old hood comes down, the new one is mounted at the height its maker specifies, connected to the duct and power, and tested on every speed.
Schedule range hood installation
Monday - Friday: 8 AM to 10 PM
Saturday: 8 AM to 10 PM
Sunday: 10 AM to 10 PM
Quoted before work begins.
Haul-away of the old unit included.
Removing the old hood. We switch off the circuit, disconnect the wiring and the duct, and take the old hood down without marking the cabinets or the wall.
Mounting height. Each hood has a minimum and a maximum height above the cooktop in its instructions, and gas cooktops usually need more room than electric ones. We mount the hood within that range, level and centered on the cooktop.
Duct connection. We connect the hood to the existing duct with the right transition, seal the joints with foil tape and check that the damper opens when the fan runs and closes when it stops.
Power. The hood plugs into an outlet in the cabinet above or connects to wiring in a junction box, matching what the old hood used. We test the fan on every speed and the lights.
Recirculating hoods. Where there is no duct to the outside, the hood is set to recirculate through charcoal filters, which need replacing every few months.

Duct size. Hoods are made for a set duct size, often 6, 8 or 10 inches round or a 3-1/4 by 10-inch rectangle. A transition fitting can join a different duct, but a hood should not be choked onto a smaller duct than its maker specifies.
Airflow. A stronger hood pulls more air out of the house, and in many jurisdictions a hood rated above 400 cubic feet per minute needs make-up air. Check the rating and your local rules before you buy a much stronger hood than the one you have.
Width. A hood as wide as the cooktop is the usual choice, and a wider one captures more smoke, especially over a gas range.
New duct runs. If the new hood needs a duct where none exists, a larger duct, a new wall or roof cap or new wiring, tell us when you book. We confirm what the job involves before the visit.
Hood installation requests from our booking form. Newest first, with the month and town only.
A Samsung hood with a burned-out motor, to be replaced with a Z-Line hood the owner had already bought.
The existing hood to come down and a new Proline hood to go up in its place.
A new KitchenAid retractable downdraft vent and cooktop to replace the old pair.
Every range hood installation is quoted before work begins. The quote depends on the type of hood, its weight and mounting, the duct and wiring connections and removal of the old hood, with haul-away included.
If the old hood only needs a motor, a switch or a light, see range hood repair. For an over-the-range microwave that vents the cooktop, see the microwave section of appliance installation.
Follow the hood’s instructions. Most makers give a range of roughly 24 to 30 inches above an electric cooktop and a little more above gas, and some pro-style hoods differ, so the spec sheet decides.
Only if a duct can be run to the outside. If your kitchen has no duct, the new hood can recirculate through charcoal filters instead.
Yes. We install the hood you purchased, including brands sold mainly online. Send the model number so we can check its duct size and mounting against your kitchen.
Yes, as a replacement for an existing downdraft or together with a new cooktop. The blower usually sits in the cabinet below, so that cabinet has to be cleared before the visit.