January 2026 · Lorton, VA
A new KitchenAid was being delivered that morning and needed installing the same day.
We install the dishwasher you bought in place of the old one. The old unit comes out, the water supply, drain and power are connected, the new dishwasher is secured and leveled, and we run it with every connection in view. The old dishwasher leaves with us.
Schedule dishwasher installation
Monday - Friday: 8 AM to 10 PM
Saturday: 8 AM to 10 PM
Sunday: 10 AM to 10 PM
Quoted before work begins.
Haul-away of the old unit included.
Removing the old unit. We shut off the water and power, disconnect the supply, drain and wiring, and slide the old dishwasher out without scraping the floor or the countertop edge.
Water supply. The new dishwasher gets a new braided supply line and the elbow fitting its inlet valve needs, connected to the shut-off valve under the sink. If that valve is old or stiff, we check that it closes before relying on it.
Drain. The drain hose rises in a high loop under the counter before it joins the sink drain, so dirty sink water cannot run back into the tub. Where the sink has an air gap on its deck, the hose connects through it.
Power. Your kitchen has the dishwasher either wired into a junction box or plugged into an outlet under the sink, and the new one is connected the same way, with a power cord kit or direct wiring as the model requires.
Securing and leveling. The dishwasher is fastened to the underside of the countertop or to the cabinet sides, leveled at all four feet and aligned with the cabinet doors. An unsecured dishwasher tips forward when the loaded door opens, which is how one of the requests below began.
Test run. We run a cycle with the connections in view and check the front of the unit and the sink cabinet for drips before we leave.

The opening. Most built-in dishwashers fit a standard 24-inch-wide opening, and compact models an 18-inch one. Measure the width, the height from the floor to the underside of the countertop and the depth, and compare them with the spec sheet of the model you bought.
The connections. Look under the sink for a shut-off valve on the hot water line, the drain connection and an outlet or a junction box. A photo of the sink cabinet with its doors open tells us most of what the job needs.
The countertop. Stone and quartz countertops cannot take screws from below, so the dishwasher is fastened to the cabinet sides instead. Most new dishwashers ship with brackets for both.
After a remodel. If the plumber or electrician is still finishing, book us for after their work. We connect to the valve, drain and power they leave in place.
Send the model number and the photos when you book, and we confirm the fit before the visit.
Dishwasher installation requests from our booking form, newest first, by month and town.
A new KitchenAid was being delivered that morning and needed installing the same day.
A Miele had to be mounted and finished once the plumbing work in the kitchen was done.
Power was already at the opening for a new LG, but it still had to be wired into the dishwasher.
A Frigidaire slid forward out of its opening whenever the door was pulled down, because it had never been secured.
A new Amana had been dropped off by the delivery crew and left uninstalled.
We quote every dishwasher installation before any work starts. The price depends on the connections your kitchen has, whether the dishwasher is wired or plugged in, the parts the job needs, such as a supply line, an elbow fitting or a power cord kit, and removal of the old unit. Haul-away is included.
If the old dishwasher may only need a pump, a latch or a door gasket, see dishwasher repair before you replace it. For other appliances, see appliance installation.
Often, if you book ahead for the delivery date and the routes have room. Tell us the delivery window so the visit comes after it.
The new dishwasher should not go in until the water can be shut off at that valve. We check it at the start of the visit and tell you before any work begins if it needs replacing.
Yes. That usually means it was never fastened to the countertop or the cabinet sides, or its feet are not level. We secure and level it and check the door alignment.
Usually not. Tell us the model, and we bring the supply line, elbow fitting and power cord kit it needs. They are listed on the quote.